Optical ruler can read but the machine can't move?
Source:Longtian
Time:2019-11-28 03:11:32
Clicks:297
Reasons:
1. The emergency stop switch is triggered
2. The motor alarm
3. The probe is enabled, but the probe is triggered (eg, the probe is abnormally triggered due to incorrect 3D measurement path planning)
1. The emergency stop switch is triggered
2. The motor alarm
3. The probe is enabled, but the probe is triggered (eg, the probe is abnormally triggered due to incorrect 3D measurement path planning)
Solution:
1. Check the emergency stop switch status and line connection.
2. Twist the coupling by hand. If the motor can be turned, the alarm or power failure may occur .
3. Prohibit the probe, move the machine, and then enable the probe after reset.